Deutschland Österreich English Great Britain

Punch set PRYOR Dot Stress


Price and information requestRequest information and prices:

 Request information and price 

Punch set dotstress – PRYOR punch set 0-9 dotstress – PRYOR punch set A-Z dotstress

 

Marking stamps “dot stress” introduce even lower stress levels than the punch “low stress” and enhance fatigue properties. Punches “dot stress” produce a character with similar rounded nose formation to low stress with the added benefit of impressing the character in a dot formation.
 
Dot stress marking stamps are used especially in the oil, gas and aircraft industry but also for power plants and similar applications. Instead of the sharp faced characters, these punches are manufactured with a radius engraving to reduce the stress levels. Please see the difference on the following illustration.
 
Schlagstempel in Punktauflösung Dot stress Prägeergebnis Dotstress Prägeergebnis Punktauflösung - Dot stress Materialbelastung - Dot stress
"Dot-stress" Result 1 Result 2 Ministress
 
Our steel stamps are manufactured of high quality Chromium tool steel. All punches are hardened precisely, giving a hardness of 58-62 R.C. at the character end and 32-40 R.C. at the striking end. Please note, that the hardness of the component should not exceed 40 R.C.
 
All sets are delivered in a strong plastic box with separate compartments for each stamp, to allow rapid selection. The production of these stamps is certificated after ISO 9001:2000. For special security requirements there is a special security holder available.
 
Marking stamps of the series "dot stress“ are available as single punch as well as in sets of A-Z and 0-9 in different sizes. All standard stamps are nickel-plated and protected therefore against rust.
 
Please, note that the size of the stamps must be measured on top at the sharp faced characters end.
 
Our punch sets “dot stress” are available as follows:
Punches – Sets A-Z “dot stress”  
   
Size Order number
Punch set 3.0 of mm PY 01017033D
Punch set 5.0 of mm PY 01019055D
Punch set 6.0 of mm PY 01021059D
Punch set 8.0 of mm PY 01027071D
   
Punches – Sets 0-9 “dot stress”  
   
Size Order number
Punch set 3.0 of mm PY 01006019D
Punch set 5.0 of mm PY 01008049D
Punch set 6.0 of mm PY 01010042D
Punch set 8.0 of mm PY 01023062D

 

Size of the blanks:

Size of the blanks

For safety reasons we recommend to use security gloves or an ocular protection when using our stamps!
 
For further information or inquiries on this product range, please contact our sales team!
 
Price: Please send us your inquiry using our contact form or put this article on our watch list for later inquiries.
 
 
Download Catalogue "Hand stamp – Punch"

 

 

Punch set 0-9 Ansetzen des Schlagstempels und Einschlagen Marking result Punch set A-Z Punches - Dot stress Punches - Dot stress Marking results Punch grip Size of the blanks - punches "Dot stress" Size of the blanks Radiengravur - Ergebnisse Schlagstempel15-110 Schlagstempel16-110 Schlagstempel17-110 Schlagstempel10-110

Copyright © Margreiter-Technik Hans Hilscher GmbH